Panel Emergency Abnormal Normal
Abnormal
False Engine Start (Engine Does Not Light) Engine Starter Will Not Disengage High Sustained ITT During Ground Shutdown Low Fuel Pressure (LH or RH Fuel Low Press Caution Light On and Master Caution) Low Fuel Quantity (LH or RH Fuel Low Level Caution Light On and Master Caution) Fuel Boost Pump On (LH or RH Fuel Boost On Advisory Light On) Fuel Filter Bypass (LH or RH Fuel Fltr Bypass Caution Light On and Master Caution) Fuel Gauge System Fault (LH or RH Fuel Gauge Caution Light On and Master Caution) Fuel Transfer (Fuel Transfer Advisory Light On) N1, N2 Flag (Yellow Dashes in Digital Readout) ITT Failure (No Pointer and Fail Displayed on ITT Tape) Loss of Oil Pressure Indication (No Pointers Displayed) Loss of Oil Temperature Indication (No Pointers Displayed) Loss of Fuel Quantity Indication (No Pointer and Yellow Dashes in Digital Readout) Loss of Fuel Flow Indication (Yellow Dashes in Digital Readout) Engine Comparator Monitor (Yellow ITT, N1, or N2 Displayed on Indicator) Loss of Engine Comparator Monitor (White ENG1, ENG2 Displayed on PFD) Single Generator Failure (LH or RH Gen Off Caution Light On and Master Caution) Aft J-Box Circuit Breaker Not Engaged (Aft J-Box CB Caution Light On and Master Caution) 250 Amp Current Limiter Blown (Aft J-Box Lmt Caution Light On and Master Caution) Bleed Air Overheat (LH or RH Bld Air O'Heat Caution Light On and Master Caution) Fresh Air Selected (Fresh Air Caution Light On and Master Caution) Environmental System Air Duct Overheat (Air Duct O'Heat Caution Light On and Master Caution) Cabin Pressurization Controller Failure Cabin Door Pressure Seal Failure (Door Seal Light On and Master Caution) Emergency Pressurization On (Emerg Press On Caution Light On and Master Caution) Environmental System Cabin Overheat Use of Supplemental Oxygen (Unpressurized) Electric Elevator Trim Runaway Electric Elevator Trim Inoperative Jammed Elevator Trim Tab Engine or Wing Anti-Ice Failure (LH or RH ENG and/or LH or RH Wing Anti-Ice Caution Light On and Master Caution) Windshield Bleed Air Failure Windshield Air Overheat (W/S Air O’Heat Caution Light On and Master Caution) Pitot-Static Heater Failure (LH or RH P/S HTR OFF, Caution Light On and Master Caution) Angle-of-Attack Heater Failure (AOA HTR FAIL Caution Light On and Master Caution) Tail Deice Timer Failure (LH or RH Tail Deice Advisory Annunciator Fails to Illuminate or Continues to Cycle) Inadvertent Icing Encounter Severe Icing Encounter Pilot PFD Failure (Blank Display) Copilot PFD Failure (Blank Display) MFD Failure (Blank Display) Dual PFD and MFD Failure (Blank Display) Autopilot Out of Trim (Yellow Boxed "E↑,↓" or "A←,→" Displayed on PFDs) Autopilot Overspeed Recovery (Yellow FLC OVRSPD Mode) Single Attitude/AHRS Failure (Yellow AP, Red ATT and White XAHS Displayed) Dual Attitude/AHRS Failure (Yellow AP, Red ATT and White XAHS Displayed) Single Heading/AHRS Failure (Yellow AP, Red HDG and White XAHS Displayed) Dual Heading/AHRS Failure (Yellow AP, Red HDG, and White XAHS Displayed) Inflight AHRS Aligning (White ATT/HDG Aligning) Standby HSI Heading Failure (Red HDG Displayed) Air Data Computer Failure (Red IAS/ALT/VS Displayed on PFD) Copilot Altimeter Failure ADC and Copilot Altimeter Failure Comparator Monitor Alert (Yellow ROL, PIT, ATT, HDG) Loss of Comparator Monitor Alerts (White XAHS) Flight Guidance Computer Failure (Red Boxed FD Displayed) AFD Crosstalk Failure (Yellow XTLK Displayed) Low Speed Cue (LSC) AOA Failure (Red AOA1 or AOA2 Displayed) Display Control Panel Failure (Red DCP 1 Displayed) Panel Avionics Fan Failure (Fan 1 and/or Fan 2 Amber Light On) Landing Gear Will Not Extend Landing Gear Will Not Retract (Gear Unlock Light Remains On) Low Hydraulic Flow (L and/or R Hyd Flow Low Caution Light On and Master Caution) Hydraulic System Remains Pressurized (Hyd Press On Advisory Light Remains On After System Cycle Is Completed) Antiskid System Failure (Antiskid Inop Caution Light On, Master Caution, and Power Brake Low Press Caution Light Out) Dispatch With Antiskid System Inoperative (Antiskid Inop Caution Light On, Master Caution, and Power Brake Low Pressure Caution Light Out) Power Brake System Failure (Power Brake Low Press and Antiskid Inop Caution Lights On and Master Caution) Wheel Brake Failure Attenuator Unlocked (LH and/or RH Attenuator Unlock Advisory Light On) ATT Stow Selected Advisory Light On and Master Caution Dispatch With Attenuator Stowed (ATT Stow Selected Advisory Light On) Speed Brakes Extended (SPD BRK Extend Advisory Light On) Flaps Inoperative Approach and Landing (Not in Landing Position) Flaps Greater Than 35° (Flaps >35° Caution Light On and Master Caution) Landing With Failed Primary Flight Control Cable Single-Engine Approach and Landing Single-Engine Go-Around Door Not Locked (Door Not Locked Caution Light On and Master Caution) Master Warning Light On Steady or Flashing, No Warning Lights Illuminated Master Caution Light On Steady, No Caution Lights Illuminated Firewall Shutoff Valve Closed (F/W Shutoff Caution Light On and Master Caution) Annunciator Video Failure (Video Fail Light On and Master Caution and Warning Lights Remain On) Annunciator Audio Failure (Audio Fail Light On)
ENGINE OR WING ANTI-ICE FAILURE (LH OR RH ENG AND/OR LH OR RH WING ANTI-ICE CAUTION LIGHT ON AND MASTER CAUTION)
NOTE
• Indicates engine inlet or wing leading edge temperature is below safe level for satisfactory ice protection. This is normal when engine/wing anti-ice is first actuated, until normal operating temperature is achieved, and if engine speed is reduced below a
IN FLIGHT (STEADY ILLUMINATION)
1. Throttle - INCREASE POWER (Above 70% N2).
2. Engine/Wing Anti-Ice Controls - CHECK SWITCHES AND CIRCUIT BREAKERS.
IF ENGINE ANTI-ICE LIGHT REMAINS ON (AFTER TWO MINUTES)
3. Respective Engine/Anti-Ice Circuit Breaker - PULL.
• Respective WING and ENGINE ANTI-ICE annunciators will be inoperative and the wing/engine anti-ice valves will open. The engine/wing anti-ice switch should remain ENG ON or WING/ENG to operate the pylon inlet heater.
4. Monitor the wing and engine inlet or leave the icing environment as soon as possible.
IF ONLY WING ANTI-ICE LIGHT REMAINS ON
3. Affected Engine/Wing Anti-Ice Switch - ENG ON or WING/ENG.
4. Wing Xflow Switch - WING XFLOW.
IF LIGHT/LIGHTS DO NOT EXTINGUISH OR REILLUMINATE
5. Leave icing environment as soon as possible.
6. After leaving the icing environment, reset circuit breaker (if applicable) and select anti-ice switches OFF.
• If landing in icing environment, use Anti-Ice On procedures.
IF ONLY WING ANTI-ICE LIGHT IS ON AND ENG/WING ANTI-ICE SWITCH IS SELECTED OFF
1. Wing Xflow Switch - WING XFLOW.
2. Respective engine - Reduce power as much as feasible.
3. LAND AS SOON AS PRACTICAL.
• If landing in icing environment, use Anti-Ice On procedures.